26"×2"×1¾", 36 hole, new chrome rims for early autocycle and trade bikes.  1mm/19 gauge (0.040") section.  Spoke hole 0.180" diameter.  Valve hole 1/4" (0.250") diameter.  £22 each.

Note: this rim size has been unavailable for a number of years now, since the last of the Van Schothorst stock dried up.  The rims are plain of any marking, but they are certainly of Chinese origin.  The section profile appears more comparable to the original Dunlop, where the Van Schothorst form used to be a little more ridged in the centre.  The welded joint, polishing, and chrome plating generally appears better than the quality typically observed on Italian Radaelli rims.  In terms of thickness, the original Dunlop rims were 18 gauge (0.048").  These Chinese rims are made from 1mm material, equivalent to 19 gauge (0.040").  The Van Schothorst rims used to be produced in 21 gauge (0.032"), which was only a light cycle gauge section, and not well suited to the powered application of autocycles.  The thicker section of these Chinese rims suggests that they should perform much better.  The pierced spoke hole size is 0.180" (the Van Schothorst rims were just the same in this aspect), which may require cleaning out slightly to build, since Suffolk Wheels report that the standard 12 gauge spoke nipple is 0.200" diameter.  The pierced (cycle) valve hole size is 1/4" (0.250"), which will require opening up to 5/16" (0.312") for anyone wishing to fit Schrader valve inner tubes.

5-way switch beam/off/dip/horn/cutout, £8.

Chrome horn button, £3.

Brake light switch, £8.

2-way beam/dipswitch, £6.

Wipac pattern contact set S1233 for Scott Cyc-Auto / BSA Bantam D1 - D7, £8.

Wipac S1233 pattern HT coil for Scott Cyc-Auto autocycles & BSA Bantam D1-D7, etc, £16.

New Villiers pattern HT coils, 1F, 2F, 4F, £20 each.

New Villiers pattern capacitor, £9 each.

Villiers JDL 18mm Bosch spark plugs, £4.

Plug cap - non-resistive, £2 each.

Headlamp: 4"/100mm lens, 5"/125mm case, c/w twin socket, chromed steel back.  New - £20.

Headlamp: 4"/100mm lens, 5"/125mm case, c/w twin socket, black steel back.  New - £15.

Rear Lamp, Lucas pattern MT110, 1¼" diameter lens, mounting 3 holes equi-spaced on 2" PCD, twin filament bayonet socket, £15.

Rear Lamp, Lucas pattern MT211, 1" diameter lens, mounting 3 holes equi-spaced on 2-1/8" PCD, twin filament bayonet socket, (this is fairly similar to old autocycle style rear lamps, but note the original mounting was 1¼" PCD), £15

Rear Lamp, Lucas pattern 477/1, 2¼" diameter lens, mounting 3 holes equi-spaced on 2" PCD, twin filament bayonet socket, £18

Rear Lamp, Lucas pattern type 679, as fitted to NVT Easy Rider models (and other British motorcycles), £9.

New Wipac S446 pattern back light unit complete, £7.

New Wipac S446 pattern rear lens, £3.50.

Headlamp clips, pack of 5 for £2.

Reflector with chrome bezel, 5mm stud mounting, £4 each.

Front suspension rubber bands for Excelsior/Francis-Barnett autocycle girder forks, £3 each. (4 per).

Front suspension rubber bands for Mobylette/Raleigh leading link forks, £3 each.

Excelsior band fork rubber buffers, £3 each. (2 per).

Honda PC50 front suspension bush kits, complete set of 8 bushes, £16.

Honda PC50 front suspension pivot bolt & tube sets in stainless steel, £16 (set of 4).

Small Lycett pattern traditional style sprung saddle for lightweight motor cycles (inc 2 × chrome plated springs), £30.

Replacement cover for lightweight motor cycle 'Small Lycett pattern' sprung saddle.  Size 12" front to back / 12" frame across inside.  Includes fitted strips for clipping to frame.
Note - These are NOT sized to fit Autocycle saddle frames, which are 10½" front to back / 11" frame across inside, £12 each.

Foam Saddle, 7/8" / 22mm stem mounting.  New, £30 each.

Trail type foam upholstered pad seat, on steel pan.  15" long × 10" wide, 4 × 8mm rear fixings 120mm × 60mm spacing, 1 × 8mm front fixing 200mm spacing, £40.

Plunger type fuel tap, 1/8" BSP (Gas) thread to tank (nominally 3/8"o/d × 28tpi), Ribbed outlet for 5mm pipe, £20 each.
Typically suits BSA Bantam; Autocycle tanks: Raynal, Excelsior; Mopeds: Norman Nippy Mark 2, 3 & 4, Lido, Hercules Her-cu-motor, etc.

Petrol pipe 5mm/6mm black neo, 80p/ft.

Petrol pipe 5mm/6mm clear, 60p/ft.

In-line Cartridge Fuel Filter, metal ends, 6mm Union, £3 each.

New petrol tap corks, barrel type (1-per), 50p each.

New petrol tap corks, blade type (2-per), 50p each.

New petrol cap seals, Cyclemaster, Power Pak, 90p each.

New petrol cap seals, Runabout, Wisp, Mini-Motor, Norman Nippy & Lido etc, £1 each.

Curly 'Bugle' bulb hooter, £5..

Straight bulb hooter, £3

Small cyclemotor bulb hooter, £3.

6V×10W DC rated chrome horn, £4.

6V AC Horn (for batteryless system), spade terminal contacts, plated finish.  New, £10.

6V AC Horn (for batteryless system), spade terminal contacts, black finish.  New, £8.

60mph Veglia Speedometer, New/Old stock, Case diameter 52mm, Head diameter 57mm, £20 each.

50mph Veglia Speedometer, New/Old stock, Case diameter 48mm, Head diameter 52mm, £20 each.

50mph A Rolle Milano Speedometer, New/Old stock, Case diameter 48mm, Head diameter 52mm, £20 each.

Huret speedo cables, 550mm, 600mm, 700mm - all lengths £6 each.

Speedo drives, VDO, Huret, Veglia, Lucia, Graisser, £8.50.

Tax disc holders, alloy rim type, £4

Tax disc holders, old fashioned Rubberlite style, £4

Tax disc holders, dual 'trade' Rubberlite, £7.

Mesh Air Filter, 50mm, for 12/14mm Bing carb, Phillips Panda, etc.  New - £9 each

New Sachs clutch plates, cork insert or bonded types, £8 each.

Fibre Washer Selection Set in organiser box.  Sizes (I/D × O/D): 3mm × 10mm, 4mm × 8.5mm, 5mm × 10mm, 6mm × 14mm, 8mm × 14mm, 10mm × 19mm, 12mm × 23mm, 16mm × 29mm.  Approx 110 pieces, £3.50p.

New 195 main jet for Gurtner carburettor, £2.

Imperial 3/8" (0.375") cotter pins, 4 for £1.

Selection of new Moby pedal shafts, £8 each.

Block type pedals, £7 pair.

Decompressor lever, blade end, cast brass & chromed, standard 7/8" bar fitting, £10 each.

Decompressor lever, ball end, chrome, £8 each.

Handlegrips, 4" long moped, 'Classic' style, £3 pair.

Handlegrips, 4" long moped, 'Ribbed' style, £3 pair.

Handlegrips, 5" long autocycle soft rubber gel grips, 7/8 pair, £3.

Q-Swiss type penknife, £3.

Cylinder black paint 100ml tin, £3.

Cylinder black paint 250ml tin, £5.

Raleigh RM1-RM2 cables, brake and clutch.

Toolbox cover stainless screws for RM4, RM5 etc, £7.50 each.

Anker Laura, Ariel 3, Batavus: new mag/clutch covers (black), £8 each.

New Cyclemaster engine mounting rubbers, 4 × bush kit £12.

Fork gaiters, 1-1/8" i/d top × 7/8" i/d bottom × 6½" long, BSA Bantam type, £10 pair.